Hi everyone! We're hard at work trying to keep our community clean, so if you see any spam, please report it here and we'll review ASAP!  Thanks a million!
16,811 Users Online
  • 206,070,767 Downloads
  • 1,870,449 Wallpapers
  • 6,937,783 Members
  • 14,832,229 Votes
  • 7,290,124 Favorites
Home Groups Popular
Sign-Up For Free! Or login to your account »
Upload Wallpapers

Galleries

Abstract Aircraft Animals Anime/Manga Architecture Boats Cars Entertainment Motorcycles Nature People Space Sports Technology Video Games
Downloads: 206,070,767
All Wallpapers: 1,870,449
Tag Count: 356,266
Comments: 2,140,956
Members: 6,937,783
Votes: 14,832,229

16,811 Guests and 0 Members Online

Most users ever online was 25250 on 5/20/26.
Get your weekly helping of fresh wallpapers!

Leave us feedback!
Support This Site
Journal for dave112 Journal for dave112
Nov
24
Tongue
How to Remove Starter for New Holland LW 130.B Wheel Loader
This instruction show you guide on how to remove and install starter for New Holland LW 130.B Wheel Loader.



Related Contents:

CNH DPA5

CNH EST 9.9

CNH eTimGo Repair Manual



Removal
NOTE: The starter is located on the left side of the engine, mounted on the engine flywheel housing.
STEP 1
Put master disconnect switch in OFF position.


STEP 2
Remove air cleaner and air cleaner bracket.


STEP 3

Remove acorn nut (1), nut (2), and washer (3) securing cover (4) to starter. Remove cover.

STEP 4
Remove nut and washer securing cables to starter B stud (5). Identify, tag, and disconnect the two cables from B stud.


STEP 5
Identify and tag rear chassis harness wire (6) connected to starter solenoid terminal. Disconnect wire from terminal.


STEP 6
Support starter and remove bolts and washers securing starter to engine. Remove starter.


Installation
STEP 7
Position and support starter on engine. Install washers and bolts to secure starter. Tighten bolts to a torque of 44 to 54 Nm (32 to 40 lb-ft).


STEP 8
Connect rear chassis harness wire (6) to starter solenoid terminal following tag installed during removal. Remove and discard tag.


STEP 9
Connect two cables to starter B stud (5) following tags installed during removal. Install nut and washer to secure cable terminals to B stud. Remove and discard tags from cables.


STEP 10
Put cover (4) on starter. Install washer (3), nut (2),and acorn nut (1) to secure cover.


STEP 11
Install air cleaner bracket and air cleaner.


STEP 12
Put master disconnect switch in ON position.

https://www.car-auto-repair.com/new-holland-electronic-service-tools-9-1-cnh-est-software-free-download/
Times Viewed: 60
0 responses have been posted to this journal entry. Post Your Response!

Previous Journal Entry

How to Remove Injector for Mitsubishi Diesel D04EG Engine? This instruction show you guide on how to remove injector for Mitsubishi diesel D04EG engine. Related Contents:Mitsubishi FUSO V.C.I Diagnostic KitMitsubishi EngineScope Diagnostic Software 12.4Procedures:(1) Remove the harness.(2) Fix the fuel inlet conn...

Next Journal Entry

How to Use SerDia2010 Diagnostic Software Droop Adjustment It is provided for using this function, that the engine is operating in min-/max governor or allspeed-governor mode (f.e. not fixspeed).SerDia reads out the actual characteristic lines for Droop and copies both values into the upper chart. Additional the ...