|
In order to guard against "racing coilovers" the first time I put the recorder installed in the car after the mention cars. I did not consider when installing wiring, but let the power cord directly hanging down, while driving, I can ignore this hanging power lines. Until one day, I have nothing else to take a demolished interior of the sled try to hide the power cord, in the absence of anything demolition case, the line will be perfectly hidden in the trim. I summed up the experience and found tachograph wiring can be very simple in fact, there are owners have similar needs friends to try it yourself!
Location tachograph installed, depending on the car after the closer the better - a greater angle shot to the center, including two near the rearview mirror to install the influence of pre-block line of sight is minimal. I tachograph between mirrors and windshield installation included, among the most centered position. Installed in this position should be noted that if the recorder in the rearview mirror and suffer too close, you may adjust the angle of impact within the rearview mirror.
� Because of this wiring without removing anything inside the car, so the tool only simple three things: skid plate, 3M double-sided tape and glue. The sled can easily tachograph line closed at trim inside; of course, if you feel your hand strength amazing, so can not pry the board, direct wiring can be completed by hand. Double-sided adhesive is used to stick one section of the power cord, will be mentioned below. As 3M adhesive can be used to secure the tachograph base, can also fixed a large harness. More detail：http://autoparts.foodblog.com/
|
| Recently Spotted MembersNo members found. Be the first. |
