Downloads: 206,081,780
All Wallpapers: 1,871,544
Tag Count: 356,266
Comments: 2,140,956
Members: 6,934,338
Votes: 14,834,697
2,735 Guests and 1 Member Online:
alinailyin
Most users ever online was 19580 on 12/21/25.
|
|
|
This post show a guide on how to use [URL=https://www.obdii.shop/goods-95-OBDSTAR-X300-DP-PLUS-PAD2-ABC-Configuration.html]OBDSTAR X300 Plus[/URL] to program remote for Chevrolet Trailblazer Duramax 2013
Purpose: generate remote -> read pincode > program remote
Car model: Chevrolet Trailblazer Duramax 2013
Tools need:
VVDI Key tool : used to generate remote firstly
OBDSTAR DP plus: used to program remote, read pincode
Reason to use them: Via OBD. no dismantling and desoldering the immobilizer box.
PS: OBDSTAR DP plus = OBDSTAR key master DP plus, their difference is the outlook.
Part 1: use VVDI Key Tool to generate remote
Generate remote -> Remote program -> Remote key
America ->Chevrolet -> Trailblazer
Use XN remote (chip ID 46 7937E)
Put battery and press [Gen].
Burn succeed.
Setup remote module into remote shell.
Part 2: Use OBDSTAR key master DP plus to program Chevrolet Trailblazer Duramax 2013 key
PS: it is very easy to do by following the on-screen message.
Read Pin code
Turn on ignition with programmed key.
Read pincode.
There is Pincode in Service Booklet: 9465
If no service booklet, then you can find by OBDII.
Tap “Enter†– GM 31.15 -> Read security Code.
By OBDII -> BCM system -> Auto
Please ensure the internet connection is fine.
Read Pincode — Logging…
Pincode: 9465
Program Chip
Back to tap: GM 31.15 -> Immobilizer-> Select from type -> Type3
Check key data: 2 keys.
Clear DTC.
All keys lost -> fill pin code:9465
Switch off for 5 seconds, then switch on.
System configuration, please wait for 10 minutes.
After 10 minutes.
Switch off and pull the key out.
Open and close driver door.
Switch on.
Whether to program next key? [Yes].
Switch off and pull the key out.
Insert new key and switch on.
Switch off and pull the key out.
Open then close driver door.
Switch on.
Whether to program next key? [NO] only 2 keys.
Switch off and pull the key out.
Open then close driver door.
Switch on
Switch off
Switch on
Program successfully.
Security light go off.
Start engine ok.
Test remote ok.
Done.
Thanks for reading.
VVDI key tool and OBDSTAR DP plus are really good match. It is really easy to do by following the on-screen message, no dismantling and desoldering the immobilizer box.
http://obd2codes.net/2020/07/07/how-to-use-obdstar-x300-plus-to-program-remote-for-chevrolet-trailblazer-duramax-2013/
|
|
|
|
