Hi everyone! We're hard at work trying to keep our community clean, so if you see any spam, please report it here and we'll review ASAP!  Thanks a million!
8,819 Users Online
  • 640,129,772 Downloads
  • 1,696,349 Wallpapers
  • 1,565,068 Members
  • 12,971,712 Votes
  • 5,965,287 Favorites
Home Groups Popular
Sign-Up For Free! Or login to your account »

dave112
Login to Become a Fan
 
ProfileWallpapers (1)Favorites (0)Journal (35)DiscussionContact Member
Journal for dave112Journal for dave112
Jul
3
Happy
How to Test Second Steering System for New Holland LW 130.B Wheel Loader
It is necessary to do second steering system test for New Holland LW 130.B Wheel Loader after replacement.



Related Contents:
CNH DPA5 Adatper
2024 New Holland Electronic Service Tools 9.10 9.2 Software Free Download



Procedures:
STEP 1
While testing, the machine must be on a clear level surface with the bucket in the travel position.



STEP 2


Press button P1 on the diagnostic center.

STEP 3

Press button P2 and highlight test.

STEP 4

Confirm the selection by pressing button P3 under“OK”.

STEP 5

Confirm the test selection by pressing button P3 under “OK”.

STEP 6

Confirm the start of the test by pressing button P3 under “GO”.


STEP 7

The system automatically activates the electric motor for the secondary steering system for 20 seconds.
NOTE: During this procedure steer the machine in both directions.

CNH EST 9.10


STEP 8

Display will verify completion of test.

STEP 9

The display will return to the test page menu, press button P1 to return to home page.

STEP 10
If the machine steering was jerky or there was no steering the secondary steering system must be repaired or adjusted.

Article resource:
https://repair-car-diy.blogspot.com/2024/06/how-to-test-second-steering-system-for.html
Times Viewed: 8Bookmark and Share
0 responses have been posted to this journal entry. Post Your Response!
Advertisement
Previous Journal Entry
Cummins CM850/CM2850 Engine Fault Code 2311 Low Power Error SolutionCummins CM850 and CM2850 engine fault code 2311,Electronic Fuel Injection Control Valve Circuit - Condition Exists. Fuel pump actuator circuit resistance too high or too low.Cummins insite 8.9.2Cummins inline 6Circuit DescriptionThe circuit is a pulse wid...Read Previous Journal Entry >>Read Previous Journal Entry >>
Next Journal Entry
How to Fit and Remove Safety Prop for Scania TruckScania Truck Fit the safety prop between the spring shackle and frame. The load on the axles is not to exceed 7.5 tonnes per safety prop.Scania SDP3 2.61Scania VCI3 Kit Clean any dirt from the air spring link before fitting the safety prop.1. Set the rear...Read Next Journal Entry >>Read Next Journal Entry >>

Recently Spotted Members


No members found. Be the first.