| Caterpillar Compression Brake Solenoid Test function allows brake wiring or solenoid problems to be identified when the engine is not running. This test does not verify proper brake valve actuation.
Related Contents:
[URL=https://www.car-auto-repair.com/caterpillar-et-2018a-electronic-technician-s
oftware-free-download/]Caterpillar ET 2023C 2019C 2018A Electronic Technician Software Free Download[/URL]
[URL=https://www.autoepccatalog.com/product/new-cat-et4-478-0235-diagnostic-
adapter-for-caterpillar-11-quality/]CAT Adapter 3 ET4 478-0235 High Quality Diagnostic Adapter[/URL]
[URL=https://www.car-auto-repair.com/caterpillar-sis-2018-full-free-download/]Caterpillar SIS 2021 2019 2018 Full EPC Service Manual Free Download[/URL]
[URL=https://www.autoepccatalog.com/product/caterpillar-18-digits-factory-pa
ssword-one-time-calculate-service/]Caterpillar 18 digits factory password calculator
[/URL]
Accessing
To run the Compression Brake Solenoid Test function:
Select “Diagnostic Tests†from the Diagnostics menu, and then select “Compression Brake Solenoid Test†from the submenu. The Compression Brake Solenoid Test screen is displayed.
Screen Layout
The Compression Brake Solenoid Test screen has the following areas:
Tree Area
The Injector Solenoid Test Tree area lists the available ECMs and the selected diagnostic test.
Note: If more than one diagnostic test is available, the selected test will be highlighted.
Display Area
The Compression Brake Solenoid Test display area has three columns:
Description – Lists the available brake solenoid numbers
Mode – Displays the current mode of the solenoid; i.e., whether it is “Powered†or “Cutoutâ€
Test Result – Displays "Open," "Short," or "OK" after the test has completed
Buttons
The Buttons available on the Compression Brake Solenoid Test screen are:
Change – Click to change the state of the solenoid. Changing the state allows for solenoid troubleshooting by “cutting out†and subsequently repowering an individual brake solenoid.
Power All – Click to return all solenoid to the powered, or active, state.
Cutout All – Click to change the state of all solenoids to cutout.
Start – Click to begin the test. Once clicked, this button is disabled until the test is stopped.
Stop – Click to stop the test. Once clicked, this button is disabled until the test is restarted.
https://www.car-auto-repair.com |
| Recently Spotted MembersNo members found. Be the first. |
